受限空间内天然气爆炸反应过程模拟分析

为定量研究受限空间内天然气爆炸反应动力学特征，开展了3个方面的研究工作，①建立了基于激波管的天然气爆炸过程数值分析模型；②将天然气气相燃烧动力学反应分解为53种反应组分、325种基元反应，给出了朗金―雨贡尼关系式和正激波的压强比、密度比和温度比计算方法；③利用化学反应模拟软件CHEMKIN构建天然气燃烧过程机理文件，对激波诱导受限空间内天然气混气爆炸过程进行数值模拟，讨论了反应过程、初始压力和空间尺寸对天然气爆炸过程的影响，并绘制了天然气爆炸温度、压力变化特征曲线。结果表明：采用入射激波模拟混气引爆过程中体系温度会出现跳跃式上升随之向下扰动；混气被引爆后温度逐步提高，在温度达到峰值时压力随之提高；提高初始压力将缩短混气引爆时间，高的初始压力可以得到更为迅速的反应速度和更高的爆炸压力；空间尺寸对散热作用的影响高于其对活性基团消毁作用的影响，小尺寸空间条件下可以获得更迅速的爆炸升压速度。     

Electrical Breakdown Properties and Space Charge Formation in High Temperature Region in Ultraviolet Ray Irradiated PVC

Polyvinyl chloride (PVC) is the most popular insulating material for electric wiring instruments. However, an exothermic reaction above 150 °C may cause deterioration of the insulating properties of PVC. Therefore, it is important to clarify the heat degradation in PVC, not only to investigate the ignition of electrical wiring products but also to use electrical products safely. It is known that ultraviolet (UV) irradiation causes chemical deterioration of PVC and an increase in its conductivity. Generally, it has been thought that the electrical breakdown properties, electrical conduction, and insulating performance are affected by space charge accumulation in an insulating material. A high temperature pulsed electroacoustic (PEA) system usable up to 250 °C has been developed, and the PEA system can measure the space charge distribution and conduction current in the high temperature range simultaneously. In this investigation, the space charge distribution and conduction current were measured up to electrical breakdown in a non‐UV irradiated sample (normal PVC) and in 353 nm and 253 nm UV‐irradiated PVC samples in the range from room temperature to 200 °C in a DC electric field. In the short wavelength UV irradiated PVC sample (253 nm, 300 h), a deterioration of breakdown strength at 90 °C to 150 °C and negative packet‐like charges were observed at 60 °C and 100 °C, a positive charge accumulated in front of both the anode and cathode above 90 °C, and a higher electric field near the cathode side because the positive charge of the cathode side was greater.     

A multiagent‐based microgrid operation method considering charging and discharging strategies of electric vehicles

In this paper, we propose a multiagent‐based microgrid (MG) operation method considering charging and discharging electric vehicles (EVs). The proposed system consists of five types of agents: single microgrid controller agent, several load agents, several gas turbines/engine agents, several photovoltaic generation agents, and several electric vehicle agents. In the proposed method, the load balancing can be realized by suppressing sudden fluctuations in supply and demand balance due to the synchronization of charging and discharging of EVs. From the simulation results, it can be seen that the proposed multiagent system could realize the load equalization in MG.     

Model-Based Design Space Exploration for FPGA-based Image Processing Applications Employing Parameterizable Approximations

The increasing demand for low power consumption and high computational performance is outpacing available technological improvements in embedded systems. Approximate computing is a novel design paradigm trying to bridge this gap by leveraging the inherent error resilience of certain applications and trading in quality to achieve reductions in resource usage. Numerous approximation methods have emerged in this research field. While these methods are commonly demonstrated in isolation, their combination can increase the achieved benefits in complex systems. However, the propagation of errors throughout the system necessitates a global optimization of parameters, leading to an exponentially growing design space. Additionally, the parameterization of approximated components must consider potential cross-dependencies between them. This work proposes a systematic approach to integrate and optimally configure parameterizable approximate components in FPGA-based applications, focusing on low-level but high-bandwidth image processing pipelines. The design space is explored by a multi-objective genetic algorithm which takes parameter dependencies between different components into account. During the exploration, appropriate models are used to estimate the quality-resource trade-off for probed solutions without the need for time-consuming synthesis. We demonstrate and evaluate the effectiveness of our approach on two image processing applications that employ multiple approximations. The experimental results show that the proposed methods are able to produce a wide range of Pareto-optimal solutions, offering various choices regarding the desired quality-resource trade-off.     

Dual closed-loops current controller for a 4-leg shunt APF based on repetitive control

ABSTRACT

Current repetitive control strategy for a 4-leg APF is usually of a poor speed in responding to the drastic changes in load harmonic profile. In this paper, a dual closed-loop current controller composed of a repetitive control-based outer loop and a PI-based inner loop is proposed to improve the performance of a 4-leg APF, with a focus on response speed and harmonic current compensation gain. The principle of the dual loop controller is explained in detail, and the stability of the system is analysed thoroughly. To further decrease the inherent time delay associated with the PWM strategy, a zero-sequence-voltage-based PWM strategy is proposed to solve the complexity in the implementation of 3D-SVPWM methods. By formulating the relationship between the duty ratio of the neutral leg control pulse and the zero-sequence-component of the reference voltages, the duty ratios of the other three legs can be calculated conveniently. The simulation and lab experiment results are provided to verify the correctness and effectiveness of the proposed dual closed-loop current controller and the zero-sequence-voltage-based PWM strategy.     

煤矿下山巷道水与空气不耦合装药爆破技术对比研究

为了提高三级煤矿许用炸药能量利用率,改善爆破破岩效果，保证开采区的工作效率，对不耦合装药结构进行优化，以理论推导的方式分别得出空气不耦合与水不耦合装药系数对爆生气体准静压力的影响，并进行了对比分析；通过实验室爆破模型试验研究水和空气径向不耦合分别作用下爆炸应力波的传播分布特性，分析峰值应力与测点到炮孔比例距离、不耦合系数之间的关系，并与理论分析对比验证。结果表明：当不耦合系数相同时，炮孔处水不耦合装药爆炸应力波峰值高于空气不耦合装药，随着不耦合系数的增加，炮孔处爆炸应力波的峰值应力减小；模型试验测得同一测点的水不耦合装药峰值应力是空气不耦合装药峰值应力的1.15~1.52倍，峰值应力作用时间长于空气不耦合装药，同一测点水和空气不耦合装药结构测得的应力波及其峰值应力均随不耦合系数的增加呈负幂函数衰减，且空气不耦合装药时衰减得更快，与理论分析一致；贵州某煤矿下山巷道，于梯形掘进断面实施传统空气不耦合装药结构掏槽爆破，效果不甚理想，运用水不耦合装药爆破技术，提高了炮孔利用率，减小了岩石破碎块度，使爆堆集中，显著提高了岩石破碎效果与出渣效率。     

Delayed Fluorescence Emitter Enables Near 17% Efficiency Ternary Organic Solar Cells with Enhanced Storage Stability and Reduced Recombination Energy Loss

Charge transfer state (CT) plays an important role in exciton diffusion, dissociation, and charge recombination mechanisms. Enhancing the utilization and suppressing the recombination process of CT excitons is a promising way to improve the performance of organic solar cells (OSCs). Here, an effective method is presented via introducing a delayed fluorescence (DF) emitter 3,4‐bis(4‐(diphenylamino)phenyl)acenaphtho[1,2‐b]pyrazine‐8,9‐dicarbonitrile (APDC‐TPDA) in OSCs. The long‐lifetime singlet excitons on APDC‐TPDA can transfer to polymer donors to prolong exciton lifetime, which ensures sufficient time for diffusion and dissociation. Concurrently, the high triplet energy level (T₁) of the DF material can also prevent the reverse energy transfer from CT to T₁. APDC‐TPDA‐containing ternary OSCs shows a high PCE of 16.96% with a reduced recombination energy loss of 0.46 eV. It is noteworthy that the ternary OSC also exhibits superior storage stability. After 55 days of storage, the PCE of the ternary OSC still retains about 96% of its primitive state. Furthermore, this ternary strategy is efficient and universally applicable to OSCs, and positive results can be obtained in different systems with different DF emitters. These results indicate that the ternary strategy provides a new design idea to realize high performance OSCs.     

基于亲生物理论的医疗空间色彩设计研究

人类在漫长的进化过程中形成了对自然的本能需求,亲生物设计从生物进化的角度以更系统和更合理的方法将自然重新融入现代建筑环境,构建人与场所之间的积极交互。源于光、水、风、植物、动物等自然元素的亲生物色彩设计具有令人愉悦的艺术感染力,动态的视觉效果暗示着蓬勃的生命力,能够系统、清晰地传递复杂的环境信息,引发观者的情感共鸣和情感依恋。从环境疗愈的角度看,具有亲生物特征的色彩设计对改善患者在医疗空间中的体验,激发患者的自我康复能力具有重要意义。亲生物设计是可持续发展设计中不可或缺的一环,两者的结合有助于创造兼具低环境影响和高情感联系的设计,以实现真正和持久的可持续性发展。     

Information system ecology: An application of dataphoric ascendancy

Information systems, like biological systems, are susceptible to external perturbations. Similar to flora and fauna in a biome, species of data can be classified within a dataphora. While entropic properties and data geometries can be used to describe local species of data within a dataphora, they are not designed to describe the global properties of an information system or evaluate its stability. Ecologists have used Information Theories to describe macro-level properties of biological ecosystems and statistical tools to evaluate biological systems. This research leverages an ecological perspective to model information systems as a living system. Our findings support the theory of dataphoric ascendancy with Wikipedia having a Diversity Index value of 0.68, within the range of 0.65 and 0.80 that indicates a balanced state. We further support our findings with additional evaluations of other ecosystems including the predicted collapse of the information service known as the Digital Universe. This research allows for an information system’s stability to be (a) characterized and (b) predicted using ecological measures specific to the diversity of data within the ecosystem.     

瞬变电磁井间勘探的全空间几何因子

井间是剩余油的主要分布区域,为探测井间剩余油,提高采收率,提出了基于全空间几何因子的瞬变电磁井间勘探方法。在本井使用线圈发射、邻井使用线圈接收,根据瞬变电磁场理论,在阶跃信号的激励下发射线圈在地层中激发出沿圆周方向的闭合瞬变电场,该电场在导电地层中产生与地层电导率呈正比的涡流。由Doll地层环模型可知,地层中的涡流在空间任意点激发得到与地层电导率成正比的二次场响应信号(有用信号),并可表示为空间各点电导率的加权平均值,其权重即为井间瞬变电磁勘探的全空间几何因子;全空间几何因子集中分布在发射线圈和接收线圈附近,其它区域分布较少,在发射线圈和接收线圈两侧呈现不同的极性;对瞬变电磁响应与地层电导率、井间距和源距的变化规律研究可知,瞬变电磁井间勘探有用信号随着地层电导率的增大而增大,随着井间距的增加单调减小,在发射线圈和接收线圈处于同一深度时该响应信号幅度最大。